pavka21 Opublikowano 6 Sierpnia 2008 Zgłoś Opublikowano 6 Sierpnia 2008 Witam, mam problem z dostaniem sie do biosu w compaq nc 4200 po wcisnieciu f10 wyskakuje Administrator password i nie pamietam hasla. Dzwonilem na suport hp-a jest to usluga platna 150zl :( Szukalem w google znalazlem pare tematow i manuala hp-ka w ktorym mozna przeczytac: -------------- 1.2 Resetting the Notebook If the notebook you are servicing has an unknown password, follow these steps to clear the password. These steps also clear CMOS: 1. Prepare the notebook for disassembly (refer to Section 4.3, “Miscellaneous Plastics/ Hardware Kit,” for more information). 2. Remove the real-time clock (RTC) battery (refer to Section 6.24, “RTC Battery,” for more information on removing and replacing the RTC battery). 3. Wait approximately 5 minutes. 4. Replace the RTC battery and reassemble the notebook. 5. Connect AC power to the notebook. Do not reinsert any battery packs at this time. 6. Turn on the notebook. All passwords and all CMOS settings have been cleared. --------- rozebralem laptopa prawie na czesci pierwsze wyjalem baterie na 10 minut i nic... bios sie zresetowal bo przy starcie mam komunikat, ze data nie ustawiona ale jak wciskam f10 to dalej prosi o haslo dostepu do biosu.... potem poczytalem i znalazlem, ze 5 minut to za malo, zeby zostawic na 30 minut ... rozebralem go jeszcze raz i zostawilem na 2 godziny.... i dalej to samo :( Help :) Cytuj Udostępnij tę odpowiedź Odnośnik do odpowiedzi Udostępnij na innych stronach Więcej opcji udostępniania...
Burns Opublikowano 7 Sierpnia 2008 Zgłoś Opublikowano 7 Sierpnia 2008 i możesz tak sobie czekać i czekać całą wieczność pass zapisany jest w pamięci eprom EPROM hasło jeżeli się zakłada, należy pamiętać jeżeli się nie pamięta laptop może być kradziony Cytuj Udostępnij tę odpowiedź Odnośnik do odpowiedzi Udostępnij na innych stronach Więcej opcji udostępniania...